Thermador PRD304GHC Manual De Instalación página 25

High Shelf Assembly
1. Remove protective plastic.
2. Slide the shelf onto the backguard panel.
.
Remove the (4) drill point screws securing the trim to
the side panels, and the (2) to (4) drill point screws
securing the piece to the back panel. Lift up to fully
re move.
I
I
I
i
I
I
©
Figure 21 : High Shelf Assembly Rear View
3. Install the included stainless screws along the topside
of shelf and into the back of the shelf.
4. Begin with Backguard Installation.
Backguard Installation
1. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim.
.
Figure 23: Flush Island Trim Rear Screw Removal
Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range (Figure 24).
©
Figure 22: Flush Island Trim Front Face Screw Removal
Figure 24: Backguard Installation
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws removed in Steps 1 and 2.
English 22