Publicidad
Idiomas disponibles
Idiomas disponibles
60
ASSEMBLY
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY (1)
A. To raise handle assembly:
•
Pull up and back on the lower handle (F) until it is aligned
with the hole position of the arm support and the mower
housing.
•
To secure the lower handle (F) in place, lock the lower
screw (M).
•
Open the upper cam locks (H).
•
Pull up and back on the upper handle to raise it into
operating position.
•
To secure the upper handle in place, close the upper cam
locks (H).
NOTE
If the upper handle is loose or separated
from the lower handle, tighten the knobs
on the upper handle locks by turning them
clockwise.
B. To lower the handle assembly:
•
Open the upper cam locks (H).
NOTE
If the handle lock is difficult to open,
loosen the knobs on the upper handle locks
by turning them counterclockwise.
•
Lower the upper handle.
•
Unfix the lower screw (M).
•
Fold the handle to the front of the unit.
•
Avoid pinching or trapping any cables.
INSTALLING THE MULCHING PLUG (FOR MULCHING OPERATION) (2)
NOTE
When using the mulching plug (B), do not
install the grass catcher.
•
Remove battery.
•
Lift and hold the rear discharge door (N).
•
Grasp the mulching plug (B) by its handle and insert it at
a slight angle.
•
Push the mulching plug (B) securely into place.
•
Lower the rear discharge door.
•
Reinstall battery when you are ready to mow.
H
B
F
M
N
Publicidad
