STEP 6: ATTACH ENGINE
1.
Attach the engine (nº47) to the wheel stand using hex bolt M8x65 (nº65), flat washer Ø8 (nº23), lock washer
Ø8 (nº22) and nylon lock nut M8 (nº19). Put polyurethane block (nº63) and big flat washer Ø10 (nº64) in the
middle engine and engine mounting plate.
STEP 7: ATTACH THE PIPE
1.
Connect the oil inlet pipe (nº26) to the connector Z 1/2"-M14*1.5 (nº60).
2.
Connect the oil return pipe (nº78) to the oil return connector of beam.
3.
Connect the oil pipe (nº62) to the gear pump (nº58) tighten with clamp (nº61).
73
65/23/22/19
78
58
60
62
61
47
64
63
1
26
63
EN