Publicidad
Idiomas disponibles
Idiomas disponibles
68
PERIODIC MAINTENANCE
WHAT?
Hoses
Hydraulic
Fittings
Nuts and Bolts
Beam
Moving Parts
NOTE: If a part needs replacement, only use parts that meet the manufacturer's specifications.
Replacement parts that do not meet specifications may result in a safety hazard or poor operations.
TROUBLESHOOTING
Cylinder rod will not move
Slow cylinder rod speed when extending or retracting
Wood will not split or splits extremely slowly
Engine bogs down during splitting
Engine stalls under low load condition
CAUSE
A - Insufficient oil to pump
B - Air in oil
C - Excessive pump inlet vacuum
D - Blocked hydraulic lines
E - Blocked control valve
F - Low control valve setting
G - High control valve setting
H - Damaged control valve
I - Internal cylinder leak
J - Fuga interna del cilindro
K - Internally damaged cylinder
L - Engine control out of adjustment
M - Engine is loaded during idle down mode
WHEN?
Inspect hoes for exposed wire mesh and leaks. Replace all worn or
Each use
damaged hoses before starting the engine.
Inspect fittings for cracks and leaks. Replace all damaged fittings
Each use
before starting the engine.
Each use
Check for loose bolts, tighten before operating.
Each use
Apply grease to beam surface.
Each use
Clear debris from log splitter
PROBLEM
Check oil level reservoir
Check oil level reservoir
Check pump inlet hose for blockage or kinks
Flush and clean the splitter hydraulic system
Flush and clean the splitter hydraulic system
Adjust control valve with a pressure gauge
Adjust control valve with a pressure gauge
Return control valve for authorised repair
Return control valve for authorised repair
Return cylinder for authorised repair
Return cylinder for authorised repair
Adjust idle control nuts
Use shorter log length (21" or less) to allow engine to speed
up before contact
HOW?
SOLUTION
A,D,E,H,J.
A,B,C,H,I,K,L.
A,B,C,F,I,K.
G,L.
D,E,L,M.
SOLUTION
Publicidad
