Publicidad
Idiomas disponibles
Idiomas disponibles
64
STEP 8: ATTACH THE LOG CRADLE
1.
Attach the log cradle (nº11) to the beam using hex bolt M10x25 (nº82) and nylon lock nut M10 (nº17).
STEP 9: ADD ENGINE OIL
1.
Make sure the log splitter is on a flat, level surface.
2.
Remove the oil fill cap / dipstick to add oil.
3.
Refer to the separate owner's engine manual for the amount needed of SAE10W-30 engine oil. Replace the
oil fill cap / dipstick.
4.
Check engine oil level daily and add oil as needed.
NOTE: During the break-in period, check the engine oil level often.
ATTENTION: Do not attempt to crank or start the engine before filling it correctly with the
recommended type and quantity of oil. Damage to the log splitter as a result of failure to follow
these instructions will void the warranty.
11
1
11
17/82
Publicidad
