BTI PROFILINE A-KS 18V Instrucciones De Manejo página 26

E N G L I S H
Use only with BTI battery packs, others
may burst, causing personal injury and
damage.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care
for the environment.
Do not incinerate the battery pack NiMH,
NiCd+ and Li-Ion.
Charges NiMH and NiCd battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.
Package depends on the type of battery
used
1 Cordless circular saw
1 Allen key
2 Battery packs, NiCd
2 Battery packs, Li-Ion
1 Charger
1 Kitbox
1 Instruction manual
1 Exploded drawing
NOTE: Model packed in the box does not include
batteries or a recharging unit.
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
WARNING: Never modify the power tool or
any part of it. Damage or personal injury could
result.
INTENDED USE
Your A-KS 18V cordless circular saw has been
designed for professional sawing applications.
DO NOT use under wet conditions or in presence of
fl ammable liquids or gases.
These heavy-duty circular saws are professional power
tools. DO NOT let children come into contact with
the tool. Supervision is required when inexperienced
operators use this tool.
1 On/off switch
2 Lock-off button
3 Front handle
4 Spindle lock
5 Dust spout
6 Saw shoe
7 Riving knife
8 Lower guard retracting lever
9 Lower guard
10 Saw blade
11 Bevel adjustment knob
12 Kerf indicator
13 Depth adjustment knob
14 Battery pack
15 Release buttons
16 Charger
17 Charging indicator (red)
Electrical Safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also
make sure that the voltage of your charger corresponds
to that of your mains.
Your BTI charger is double insulated in
accordance with EN 60335; therefore no earth
wire is required.
If the supply cord is damaged, it must be replaced by
a specially prepared cord available through the BTI
service organization.
Mains Plug Replacement
(U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing
and you are competent to do this,
proceed as instructed below. If you are in
doubt, contact an authorized BTI repair
agent or a qualifi ed electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely;
a plug with bared copper conductors is
dangerous if engaged in a live socket
outlet.
26