EINHELL TP-DWS 18/225 Li BL Manual De Instrucciones Original página 18

2. Extraction takes place directly through the
abrasive paper and the grinding/sanding disk
(8) into the dust bag (11).
To seal the dust catch bag (12) so that it is dust-
tight, proceed as follows (Fig. 5)
1. Close the dust catch bag (11)
2. Roll it up as far as the white line
3. Connect the quick-release lock together
To open the dust catch bag (11), proceed in re-
verse order. (Fig. 6)
Caution:
For health safety reasons it is imperative that you
use a dust extractor.
5.2 Attaching the abrasive paper (Fig. 7)
The hook-and-loop fastener enables easy chan-
ging of the abrasive paper. Make sure that the
vacuum extraction holes on the abrasive paper
and the sanding disk are aligned.
5.3 Adjusting the additional handle
(Fig. 8 / item 4)
You can turn the additional handle (4) into the
most comfortable position for you.
•
Undo the two fastening screws for the additio-
nal handle (5).
•
Adjust the additional handle (4).
•
Re-tighten the two fastening screws for the
additional handle (5).
5.4 Charging the Li battery pack (Fig. 12-13)
1. Remove the battery pack (d) from the handle,
pressing the pushlock button (e) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the socket outlet. The green LED will then
begin to fl ash.
3. Push the battery pack (d) onto the battery
charger.
In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
Anl_TP_DWS_18_225_Li_BL_SPK13.indb 18 Anl_TP_DWS_18_225_Li_BL_SPK13.indb 18
GB
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.5 Battery charge level indicator
(Fig. 12/Item g)
Press the button for the battery charge level indi-
cator (h). The battery charge level indicator (g) will
indicate the charge status of the battery by means
of 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
- 18 -
27.06.2023 15:15:19 27.06.2023 15:15:19