Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting with the Dreamehome App
EN
Scan the QR code on the robot, or search "Dreamehome" in the app store to
download and install the app.
R
L
QR code
R
L
OFF ON
2. Add Device
Open the Dreamehome app, tap " " in the upper right, and scan the same
QR code again to add the device. Please follow the prompts to finish the
Wi-Fi connection.
R
L
QR code
L
R
OFF ON
10
Note:
· Only 2.4 GHz Wi-Fi is supported.
· Due to upgrades in the app software, the actual operations may differ
from the directions in this manual. Please follow the instructions
based on the current app version.
3. Reset Wi-Fi
Simultaneously press and hold the buttons
and
until you hear a voice
prompt saying, "Waiting for the network configuration." Once the Wi-Fi
indicator turns solid white, the Wi-Fi has been successfully reset.
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and
add the device again.
Wi-Fi Indicator
· OFF: Unconnected
· Quick Blinking White:
Releasing the hotspot
· Slow Blinking White: Connecting
· Solid White: Connected
How to Use
1. Rocker Switch
Press the ON/OFF rocker switch on the bottom to activate the robot.
2. Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the charging dock, the
robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the dock and press and hold the
button for 3
seconds.
3. Fast Mapping
After configuring the network for the first time, follow the instructions on
the app to quickly create a map, and the robot will start mapping without
cleaning. The mapping process will be completed when the robot returns to
the dock, and the map will be saved automatically.
4. Start Cleaning
Press the button
briefly to start cleaning after the robot is turned on.
Then, the robot will accurately map out a route, methodically clean along
the edges and walls, then finish by cleaning each room in an S-shaped
pattern to ensure a thorough job.
Note: If vacuum only, please remove the mop pad holder.
5. Cleaning Mode
The robot has four cleaning modes: Quiet, Standard, Strong, and Turbo.
The default mode is Standard. You can specify the cleaning mode in the
app.
6. Pause/Sleep Mode
When the robot is running, press any button to pause it. If the robot is
paused for more than 10 minutes, it automatically enters sleep mode. All
indicators on the robot will turn off. Press any button on the robot, or use
the app to wake up the robot.
Note: If the robot is paused and placed onto the charging dock, the current
cleaning task will end.
7. Spot Cleaning
When the robot is paused or in Standby Mode, press and hold the button
3 seconds to start Spot Cleaning Mode. In this mode, it will clean a square-
shaped area of 1.5×1.5 meters directly around the robot. When the spot
cleaning is done, the robot will automatically return to its original location and
stop working.
Note: Activating Spot Clean Mode will end the current cleaning task of the robot.
8. Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator goes out. The DND
mode is disabled by default at the factory. You can use the app to enable the
DND mode or modify the DND period. The DND period is 22:00-8:00 by default.
Note:
· The scheduled cleaning tasks will be performed on time during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
EN
for
11
Publicidad
