How to Use
EN
9. Scheduled Cleaning
You can schedule cleaning time in the Dreamehome app. The robot will
automatically start cleaning at the designated time and then return to the
charging dock to recharge when the cleaning is done.
10. Additional App Functions
Follow the instructions on the app interface to use more functions. The version
of the app might have been updated; please follow the instructions based on
the current app version.
11. Use the Mopping Function
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
1) Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
②
①
③
12
2) Fill the tank with water.
Note:
· It is recommended to remove the dust box before filling the tank with water, to
avoid dampening the dust box.
· Do not use detergent or disinfectant.
3) Slide the 2-in-1 water tank with dust box and mop assembly into the
back of the robot until it clicks into place. Press the button
or use the
Dreamehome app to start cleaning.
Click
Click
Note:
· It is not recommended to use the mopping function on carpets.
· Use the app to adjust the water flow as required.
Routine Maintenance
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
Maintenance
Part
Replacement Period
Frequency
Mop pad
After each use
Every 3 to 6 months
Main brush
Every 6 to 12 months
Dust box's filter
Once every 2 weeks
Every 3 to 6 months
Side brush
Charging dock's
signaling area
Charging contacts
Omnidirectional wheel
/
Once every month
Bumper
Point laser sensor
Edge sensor
Cliff sensors
Water tank
Clean it as needed
/
Dust box
Note: The replacement frequency will depend on your usage of the robot.
If an exception occurs due to special circumstances, the parts should be
replaced.
EN
13