Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
INSTALL OPERATOR
1. Install the operator using the appropriate manual.
2. Determine the length of shaft needed to connect the operator to the
double idler assembly and cut the shaft provided to that length.
3. Install the last 48B14 sprocket to one end of the extension shaft with
the 1/4" x 1-3/4" roll pin provided (Figure 3).
4. Slide the last two bearing assemblies onto the end of the shaft. Place
one of the bearings in the center of the shaft. The other bearing should
be placed as close to where the operator driven sprocket will be.
5. Remove the 50B12 sprocket from the operator and replace it with the
50B20 sprocket provided. Install the 50B12 sprocket on the extension
shaft just installed.
Figure 3
Front Idler Assembly
Slider Assembly
(2 Places)
Connecting Shaft
Idler Roller
(2 Places)
NOTES:
1. Smaller sprocket (50B12) is mounted on the extension shaft.
2. Larger sprocket (50B20) is mounted to the operator where the
(50B12) sprocket was removed.
3. Bearing assembly should be mounted as close to the (50B12)
sprocket as possible to prevent shaft flex.
4. Refer to owner's manual for instructions on reversing operator
direction.
Figure 2
Extension Shaft,
Runs to Operator
Chain Coupling
Bearing Assembly
(3 Places)
(4 Places)
Extension Shaft
2
48B14 Sprocket
Connecting Shaft
Double Idler Assembly
Couple Sprockets Together with
#40 Chain and Master Link
Track
Spacer
Double Idler Assembly
See Note 3
Sprocket 50B20
(See Note 2)
Track
Spacer
Single Idler Assembly
Sprocket 50B12
(See Note 1)
Publicidad
