Dörr SNAPSHOT CLOUD PRO 4G Manual De Instrucciones página 30

06.7 DÖRR SnapShot Cloud 4G/4G Pro website
You may also register and log in via our website with your PC/laptop:
https://www.doerr.cloud/
We recommend using Google Chrome Browser
NOTICE
The appearance/symbols in the app and on the website may vary.
However, the settings and functions are identical and as described
in the following chapters.
06.7 Switch on / Camera status check
After you have switched on the camera, the camera will now check
all relevant functions. During this process, the operating status LED
(17a) and all other LEDs flash green. As soon as the operating status
LED (17a) lights up green continuously
your camera is ready for registration/use.
Unregistered camera:
Camera remains in registration mode for 5 minutes. After this, the
camera switches to standby mode (see chapter 07.2) and the LEDs
and PIR LED indicator (02) go out.
Already registered camera:
After approx. 1 minute, the camera switches to the defined working
mode (LEDs and PIR LED indicator (02) go out).
You can return to the status view (LEDs light up) at any time by
pressing the TEST button (13).
NOTICE
When setting up your camera for the first time, the LED status in-
dicators (17f) and (17g) flash
been successfully registered. Registration is complete as soon as
you have clicked on Save settings
page 35).
Should a critical error occur during the check, the operating status
LED (17a) will light up red constantly
as for information on the other LED status indicators (17b - 17e), please
read the table below (chapter 06.7.1).
30
.
, the check is complete and
green until the camera has
in the app/web interface (see
. For troubleshooting, as well
IMPORTANT
If the LED status indicators
up or flash red , please contact our service department at
+49 731 970 37 69 or by email at hello@doerr.gmbh.
(17f) and/or (17g) light
doerr-outdoor.de