Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside using warm water with a
low concentration of dishwashing liquid. Do not use abrasives or scouring powder; they may scratch the
surface finish.
USAGE
CAUTION! Wine cabinets are intended only for storing and preserving wine.
IMPORTANT: Your wine cabinet is ideally suitable for holding Bordeaux type bottles of 0.75 L capacity. It
can contain larger bottles; however care must be taken that they do not prevent the door from closing
properly.
-
When closing the door ensure that it does not touch any of the bottles.
-
If you load several bottles at a time, it will take longer before the cabinet reaches the desired
temperature.
-
In order to avoid damaging the door seal, ensure that the door is fully open before moving the
racks along the compartment rails.
Adjusting the temperature
LB468/LBN468:
1 - Start/Stop button
2 - Light button
3 -Digital display of the temperature in the upper
zone
LB178/LBN178
1 - Start/Stop button
2 - Light button
3 - Digital display of the temperature in the lower
zone
Starting the appliance
Press the start/stop button for about 3 seconds
Do the same to turn it off.
Temperature control
The internal temperature is regulated by the electronic thermostat controlled by the buttons inside the
appliance.
1
3
2
1
3
2
USAGE
4
4 - Digital display of the temperature in the lower
zone
5 - Setting button for the upper zone
6 - Setting button for the lower zone
4
4 - Digital display of the temperature in the upper
zone
5 - Setting button for the upper zone
6 - Setting button for the lower zone
5
6
6
5
66