Le Chai LB178 Instrucciones De Uso página 67

Each time the "upper zone" or "lower zone" key is pressed, the selected zone is incremented by one
degree. To obtain a temperature lower than the one indicated,
You can adjust the temperature degree by degree. The temperature is set using the arrows 5 or 6 on the
right of the temperature indicator.
After the temperature is selected, the display will flash for 5 seconds and display the set-point
temperature. If you want to know the actual temperature in the cellar, you must press the arrows 5 and 6
at the same time for 3 seconds; after 5 seconds, the set-point temperature will be displayed again.
Notes :
LB178/LBN178: The range of temperature of this wine cellar is between 5°C and 10°C in the lowerr zone
and between 10°C and 18°C in the upper zone.
LB468/LBN468 :The range of temperature of this wine cellar is between 5°C and 10°C in the upper zone
and between 10°C and 18°C in the lower zone.
Control of the light
To turn on or off the internal light, press the button.
The (LED) light is suitable for the conservation of wine.
In order to reduce energy consumption, the LED light goes off automatically after 10 minutes. However,
we recommend turning off the light under normal use or after each use. However, if you wish to leave the
light on, the procedure is as follows; press button 2 for at least 5 seconds; the display will then show "LP".
After a few seconds, the display comes back to the temperature indication and the light stays on
continually. To return to the light turning off automatically after 10 minutes, press button 2 for at least 5
seconds; the display will then show "LF". After a few seconds, the display comes back to the
temperature indication and the light goes off automatically.
Note
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the Wine cooler will not start.
To avoid too much condensation when the ambient temperature is higher than 28°C, do not lower
the temperature below 7°C.
When you use the Wine cooler for the first time or restart the Wine cooler after having been shut
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation time.
Once the Wine cooler is running for a few hours everything will be back to normal.
DEFROSTING
Defrosting of your wine cabinet is fully automatic. It requires no action on your part.
During operation, you may notice condensation drops forming on the rear inside wall of the cabinet. They
will be eliminated during automatic defrosting.
CLEANING
Before any cleaning, unplug the device from the mains.
Never use abrasives or a scraper sponge when cleaning the inside or the outside of your wine
cabinet.
Remove all accessories (racks, etc.). Wash them using lukewarm water to which has been added a
gentle unscented detergent (dishwashing liquid for example); rinse with bleach water and carefully
dry off.
Wash the inside walls in the same way; pay particular attention to the rack supports
Wash the door seal as well as under the seal.
Plug the wine cabinet into the mains.
CARE OF YOUR CABINET
67