Worx Nitro WX542. Serie Manual Original página 11

Vibration emission value a
=6.83 m/s
cutting boards
Uncertainty K = 1.5 m/s²
Vibration emission value a
cutting steel
6.49 m/s
metal
Uncertainty K = 1.5 m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
20V Cordless Brushless Jigsaw
h,B
2
=
h,M
2
4. OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight and curved
cuts. The saw blade recommendations are to be
observed.
ASSEMBLY AND
OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Blade Installation
NOTE: Ensure the blade is
installed in place. The black line
on the blade needs to be totally
inserted into the tool-free blade
holder.
Blade Removal
NOTE: Hold the blade with one
hand when remove the blade.
Vacuum Adapter Installation
Vacuum Adapter Removal
NOTE: Press and hold the
projection on the bottom of the
vacuum adapter before pulling it
out of the machine.
OPERATION
Pendulum Function
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
11
See Fig. B1
See Fig. B2
See Fig. B3
See Fig. B4
See Fig. C
EN