Publicidad
Idiomas disponibles
Idiomas disponibles
Safety On/Off Switch
NOTE: For safety reasons the
On/Off switch of the machine
cannot be locked; it must
remain pressed during the entire
operation.
Increasing or reducing the
pressure on the On/Off switch
enables stepless stroke-rate
control of the switched-on
machine.
Straight Cut and Curve Cut
Bevel Cut
NOTE: Remove the vacuum
adapter before adjust the base
plate.
NOTE: Rotate the base plate to
the desired position according
to the scale. Ensure the blade
is engaged between the blade
positioning wheel .
Plunge Cut
5. WORKING HINTS FOR
YOUR JIGSAW
12
12
If your power tool becomes too hot, please run your
jigsaw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Always use a blade suited to the material and
material thickness to be cut. For tight curves it is best
to use a narrow saw blade. When sawing metal or
similar materials, apply coolant/lubricant alongside
the cutting line.
Always ensure the workpiece is firmly held or
clamped to prevent movement. Any movement of
the material may affect the quality of the cut. The
blade cuts on the upward stroke and may chip the
uppermost. Ensure your uppermost surface is a non-
visible surface when your work is finished.
For easier control, use low speed to start cutting and
then increase to correct speed.
In order to avoid operation malfunctions, do not saw
gypsum board from below or overhead.
The guide roller should occasionally be checked for
wear and lubricated with a drop of oil. If it is worn, it
must be replaced.
6. MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
20V Cordless Brushless Jigsaw
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
See Fig. D
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C.
See Fig. E1, E2
7. TROUBLESHOOTING
See Fig. F1-
Symptom
F3, G
The tool
suddenly
See Fig. H1,
stops
H2
during
operation.
8. ENVIRONMENTAL
PROTECTION
Possible
Possible Solution
Causes
Overload
Relieve the load
Battery
on the machine
temperature
immediately and allow
too high
cooling for approx. 30
seconds by running
the machine on no-
load.
Low battery
Charge the battery
capacity
pack.
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
EN
Publicidad
