Publicidad
STEP 16
Hammer Block
I
E
end view
Position and insert the locking pins (6) of the Adjustable Shelf Rail (I) into the edge holes of the
Adjustable Shelf (E) as shown.
Be sure both parts are positioned as shown. Place the hammer block on top of molding in each of the
3 locking bolt locations and give a firm strike to lock together. The locking pin (6) will snap into the
locking sleeve (7).
IMPORTANT NOTICE: Once locked together, parts cannot be separated.
Note: A rubber mallet can be used in place of a hammer and hammer block.
26
systembuild.com
You
Tube
Publicidad
