Toto TES201AB Serie Manual De Instalación Y Del Propietario página 13

PERIODIC MAINTENANCE - Nozzle
6. Remove the filter from the hot water, and
clean it with a soft brush.
Rinse the filter and dry it with a soft cloth.
7. Remove the nozzle from hot water. Use a
bent paper clip to remove any soap
clogging the 4 small holes at the soap inlet.
8. Attach the filter onto the nozzle when cleaning
is complete. Use the hex key to secure the
nozzle back onto the spout with the screw.
Insert the nozzle into the spout until the screw hole is
hidden.
Make sure the nozzle is fully secured and does not
come off.
Note
Activate the dispense to make sure no
leaking occurs.
(Continued)
Filter
Toothbrush
Bent paper clip
4 small holes
How to attach the nozzle
Caution
Always attach the nozzle with the
dispensing outlet facing downwards.
Otherwise the soap may spill everywhere.
Insert the nozzle
until the screw hole
is hidden
24
PERIODIC MAINTENANCE - Nozzle
[ For the TLK0800*G model ]
Clean the nozzle periodically as the soap cannot flow if the nozzle is clogged.
1. Unplug from the power outlet.
2. Use a Phillips head screwdriver to loosen
and remove the screw.
(Turn the screwdriver about 10 turns.)
Caution
If you clean the nozzle in a sink, make sure to
cover the drain to prevent losing the small parts.
3. When the screw is completely loose, pull the
nozzle out to remove it.
4. Pinch the filter and pull it out from the nozzle.
5. Leave the nozzle and the filter to soak in hot
water for a few minutes.
Note
This makes it easier to remove any soap that
has adhered to the nozzle.
(Continued)
Nozzle
Loosen
Phillips head
screwdriver
Make sure to fully insert the screwdriver tip
before loosening the screw. If the Phillips head
screwdriver is not properly inserted, the screw
head may be deformed.
Gently pull upwards at
a slant
Remove
Filter
25
Screw