Toto TES201AB Serie Manual De Instalación Y Del Propietario página 14

PERIODIC MAINTENANCE - Nozzle
6. Remove the filter from the hot water, and
clean it with a soft brush.
Rinse the filter and dry it with a soft cloth.
7. Remove the nozzle from hot water. Use a
bent paper clip to remove any soap
clogging the 4 small holes at the soap inlet.
8. Attach the filter onto the nozzle when cleaning
is complete. Use the Phillips head screwdriver
to secure the nozzle back onto the spout with
the screw.
Note
Activate the dispense to make sure no
leaking occurs.
(Continued)
Filter
Toothbrush
Bent paper clip
4 small holes
How to attach the nozzle
Caution
Always attach the nozzle with the
dispensing outlet facing downwards.
Otherwise the soap may spill everywhere.
Insert the nozzle
until its end
touches the main
body of the spout.
26
PERIODIC MAINTENANCE - Nozzle
1. Pull out the power plug.
2. Turn the nozzle by hand to unlock.
3. Grab the projection on the nozzle with a
tool such as long-nose pliers and pull out
the nozzle and the filter.
4. Clean (Wash with water) the nozzle and the
filter.
Caution
If you wash the nozzle in a wash bowl, block
the drain outlet. This part is small and may be
lost.
Note
After washing them with water, wipe off
moisture with a dry soft cloth.
If you use hot water for cleaning, dirt is
washed off more easily.
5. After washing the nozzle and the filter,
mount them back again.
When mounting the nozzle, turn it by hand
so that it locks with the spill hole to the
lower side.
* The nozzle is made so as not to insert
reversely.
Note
After the nozzle has been mounted, turn on
the liquid soap, and make sure that water does
not leak from the outside of the nozzle.
(Continued)
Unlock
Nozzle
O-ring
Filter
Tool
How to mount the nozzle
View from below
Spill ports
* Be sure to mount the nozzle so that the spill
hole comes to the lower side. Otherwise,
liquid soap may leak.
27