Craftsman 171.926501 Manual Del Propietário página 15

MOUNTING THE ROUTER TO
THE ROUTER TABLE--THREE
HOLE MOUNTING PATTERN
(Figs. 7 and 8)
I _WARNINGI Always m ake sure
that the router is NOT plugged into an
electrical outlet or the switch when the
router is being installed on the router
table. If it is, UNPLUG the power cord
from the outlet or the switch, and
UNPLUG the switch from the outlet.
With the fence moved toward the back of
the table, mount the router to the table:
1. If held in place by screw fasteners,
remove the plastic sub-base from the
router (see your router manual for
instructions).
2. While holding the router upside down,
position the router against the bottom
of the router table, centering the collet
in the hole. If the router has a vacuum
port, it should face the back of the
table. Align the three threaded holes
in the router base with the three
countersunk holes in the tabletop
(Figs. 7 and 8). It may help to support
the router with a block of wood.
3. Mount the router to the tabletop with
three #10-32 x 5/8" countersunk
Phillips head machine screws (20).
Tighten the screws securely.
! Figure 7 _ _li._bi_
Craftsman Router_V"
model 17508
router shown
I Figure 8
I/
:
p a oum
15