TLX-3 illustré avec robinet et distributeur de savon Verge™
Turn OFF electrical power to the electrical outlets, then unplug all electrical units prior to installation.
Electrical power MUST remain off until installation is complete.
Installer's hardware must be appropriate for wall construction. Wall anchors must have a minimum pull-out
rating of 1,000 lb.
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer. Product warranties may be found under "Products" on our
website at bradleycorp.com.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
For standard height mounting, do not exceed the recommended 33.5" distance from the fixture rim to the
finished floor.
215-1902 Rev. C: ECO 20-08-028B
© 2021 Bradley
Page 1 of 73
1/21/2021
GLX-3 shown with WashBar Duo WBD1
GLX-3 illustré avec WashBar Duo WBD1
Se muestra GLX-3 con WashBar Duo WBD1
TLX-3 shown with Verge™ Soap & Faucet
Se muestra TLX-3 con llave y jabón Verge™
WARNING
NOTICE
IMPORTANT
Installation
GLX-3 and TLX-3
Express Lavatory System –
GLX & TLX Series
Système lave-mains Express –
Série GLX et TLX
Sistema de lavabo Express –
Series GLX y TLX
Menomonee Falls, WI 53052 USA
800 BRADLEY (800 272 3539)
+1 262 251 6000
P.O. Box 309
bradleycorp.com