Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Release the bail switch before you adjust the chute
deflector.
WARNING
Do not push the deflector so far forward that a gap shows
between the deflector and the chute.
1. Push and hold the trigger (22) on the chute deflector (6).
2. Move the chute deflector (6) up to increase the snow
distance.
3. Move the chute deflector (6) down to decrease the snow
distance.
8.7
OPERATION TIPS
•
If it is possible, clear the snow with the direction of the
wind.
•
In strong winds, lower the chute deflector to direct the
snow to the ground.
•
When you complete the work, let the machine operate for
a while to prevent ice formation in the discharge chute.
•
If the snow is deeper than 8", decrease the speed and let
the machine work at its own rhythm.
•
Do not use the scraper to remove compact snow and ice.
9
MAINTENANCE
WARNING
Remove the battery pack from the machine before
maintenance.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
9.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the remaining snow on the machine with a brush.
English
9.2
REPLACE THE SCRAPER
Use only approved replacement scrapers.
Wear heavy gloves around the blade when you touch the
blade.
The scraper is located at the bottom of the impeller housing.
Ensure that the battery is not installed in the tool.
1. Turn the machine to its side.
2. Remove the 5 bolts (17) below the deck that attach the
scraper (9) to the machine.
3. Remove the worn scraper (9) from the machine.
4. Install the new scraper (9).
5. Install and tighten the bolts (17) that you removed.
11
WARNING
WARNING
WARNING
EN
Publicidad
