MotionBlinds CM-08-E Guía De Configuración página 22

Deactivate direct control for remote control
When pressing the up or down button on the remote control, the blind directly moves to its end positions
(direct control). To operate the blind with smaller steps using the up and down button, direct control can be
deactivated. Now, the blind only directly moves to its end positions when the up or down button is held longer
than two seconds.
Press the program button on the motor to activate program mode. The blind starts stepping.
.1
Hold the program button until the blind stops stepping (approximately 5 seconds) to deactivate or
.2
reactivate direct control.
22
Short press
+
5 s