MotionBlinds CM-08-E Guía De Configuración página 6

Set end positions
5
Beside setting the end positions by the app you are able to set the end positions by pressing the
button on the motor. 1: To enter this program mode make sure the USB-C cable is connected and
powered (see page3). 2: Pull and hold the chain until the blind has reached the bottom position.
If the blind moves in the opposite direction, release the chain and pull and hold again.
Adjust until the desired bottom position has been reached.
6
Save your bottom position
6
When your blind is positioned at your bottom position hold the button until the blind moves up
and down to save your bottom position.
1
2