Beurer EM 59 Heat Instrucciones De Uso página 28

General information
If you wish to return to the previous selection menu, press the MENU
button. By pressing and holding the ENTER button, you can skip in-
dividual setting steps and start directly with the stimulation treatment.
Keylock
Locks the buttons to avoid them being pressed unintentionally.
1. To activate the keylock, hold down the ENTER button until the
symbol is visible in the display (approx. 3 seconds).
2. To deactivate the keylock, hold down the ENTER button again un-
til the symbol disappears from the display (approx. 3 seconds).
Pausing use
You can pause the stimulation at any time by briefly pressing the ON/
OFF button . To continue the stimulation, briefly press the ON/OFF
button again and set the desired impulse intensity again.
8. HEAT
In addition to the TENS/EMS/Massage programs, the EM59 Heat also
offers two heat levels, which can be activated as required for all programs,
see section 5.2 on usage. The heat emitted by the gel pads relaxes the
muscle and improves circulation. You can activate the first level of the
heat function by pressing the Heat button. Then wait a moment until the
temperature stops increasing. If the temperature is too low for you, you
can activate the second level of the heat function by pressing the Heat
button again. If you would like to deactivate the heat function, you can do
so by pressing the Heat button again
If you want to use the heat function separately, without additional stimu-
lation, proceed as follows:
Step 1: Position the electrodes in your desired target area. (See section
"7.4 Information regarding the positioning of electrodes" for placement
suggestions) and connect them with the device
Step 2: Press the ON/OFF button to switch on the device
Step 3: Press the Heat button in order to access the Heat settings
Step 4: Use the / setting buttons to select the treatment time you want
and press the ENTER button to confirm your selection
Step 5: Press the Heat button again in order to switch on the first level
of the heat function. Then wait a moment until the temperature stops in-
creasing. If the temperature is too low for you, you can activate the sec-
ond level of the heat function by pressing the Heat button again.
9. PROGRAM OVERVIEW
The digital EMS/TENS unit features a total of over 70 programs:
• 15 TENS programs
• 35 EMS programs
• 20 MASSAGE programs
In all programs you can set the impulse intensity of both channels indi-
vidually.
You can also set various parameters in TENS programs 13–15 and EMS
programs 33–35 to adjust the stimulating effect to the application area.
28