Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
If engine dies with the choke lever
in the OFF CHOKE
position,
move
the
choke lever to the HALF CHOKE position
and pull the rope until engine runs, but no
more than 6 pulls.
Choke
position
decal
STARTING
A WARM
ENGINE
1.
Move ON/OFF
switch to the ON position.
2.
Move
the
choke
lever
to the
HALF
CHOKE
position.
3.
Squeeze
and
hold the throttle
trigger.
Keep throttle trigger fully squeezed
until
the engine runs smoothly.
4.
Pullstarter
ropesharply
until engine runs,
but no more than 5 pulls.
5.
Allow
engine
to run 15 seconds,
then
move the choke lever to the OFF CHOKE
position.
NOTE:
If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded.
STARTING
A FLOODED
ENGINE
Flooded
engines
can be started
by placing
the choke lever in the OFF CHOKE
position;
then. pull the rope to clear the engine of ex-
cess fuel. This coutd require pulling the starter
handle many times depending
on how badly
the unit is flooded.
If
the
unit
still
doesn't
start,
refer
to
TROUBLESHOOTING
TABLE
or
call
1-800-554-6723.
OPERATING
THE
COUPLER
This model is equipped
with a coupler
which
enables
optional attachments
to be installed.
The optional attachments
are:
MODEL:
Edger .......................
PP1000E
Cultivator
....................
PP2000T
Blower
......................
PP3000B
Brushcutter
..................
PP4000C
WAR
NIN G:
Always stop unit and dis-
connect
spark plug before removing
or instal-
ling attachments.
REMOVING
PRUNER
ATTACHMENT
(OR OTHER
OPTIONAL
ATTACH-
MENTS)
CAUTION:
When removh_g or installing at-
tachments,
place the unit on a flat surface
for
stability,
Loosen
the coupler
by turning
the knob
counterclockwise.
Upper Shaft
Coupler
Lower
Attachment
TIGHTEN
Knob
Press and hold the locking/release
button.
Locking/Release
Button
Upper Shaft
Lower Attachment
3.
While securely
holding
the engine
and
upper shaft,
pull the attachment
straight
out of the coupler.
INSTALLING
OPTIONAL
ATTACH-
MENTS
1.
Remove
the shaft cap from the attach-
ment (if present).
2.
Position locking/release
button of attach-
ment into guide recess
of coupler.
3.
Push the attachment
intothe coupIer until
the locking/release
button snaps into the
primary hole.
4.
Before using the unit, tighten the knob se-
curely by turning clockwise.
Couple r
Primary
Hole
Guide Recess
Upper
Locking/
Attachment
Shaft
Release
Button
="=WARNING:
Make sure the locking/
release
button
is locked
in the primary hole
and the knob is securely
tightened
before op-
erating the unit.
INSTALLING
ATTACHMENT
HANGER
An attachment
hanger is provided for storage
when attachment
is not in use.
To install hanger on attachment:
1.
Remove
the shaft cap from the attach-
ment (if present)
and discard.
2.
Press and hold the locking/release
button.
3.
Push hanger onto the attachment
until the
locking/release
button snaps into the hole.
11
Publicidad
