Original Prusa XL Manual Del Usuario página 26

PASO 14 Wi-Fi antenna holder versions
The antenna connector is prepared by the manufacturer:
Version A: The Wi-FI antenna holder is on the side. Continue to the next step.
The antenna connector has to be assembled by you:
Version B: The Wi-Fi antenna holder is in the middle. Please skip to Version B:
Connecting the extruder cable.
PASO 15 Version A: Connecting the extruder cable
Locate the xl-rear-cable-management-plug (cover) on the rear of the printer.
Loosen two screws on the cover slightly. No need to remove them completely. Push
the cover to the right and remove it from the printer.
Connect the extruder cable to the upper slot labeled DWARF 1.
Attach the connectors cover to the screws. Push it all the way to the right and
tighten the screws.
26
3. Instalación de la impresora
Original Prusa XL Mono Cabezal (Ensamblada)