Original Prusa XL Manual Del Usuario página 29

PASO 20 Version B: Installing the Wi-Fi antenna: antenna preparing
Push the antenna connector through the Wi-Fi-antenna-holder.
Insert the thinner washer back onto the connector.
Using the universal wrench, tighten the nut on an antenna connector.
Good job! The Wi-Fi antenna is prepared.
PASO 21 Version B: Connecting the extruder cable
Locate the xl-rear-cable-management-plug (cover) on the rear of the printer.
Loosen two screws on the cover slightly. No need to remove them completely. Push
the cover to the right and remove it from the printer.
Loosen four screws securing the electronics cover. Remove the cover.
Connect the first dock (from the right side) cable to the upper slot labeled DWARF
1.
3. Instalación de la impresora
Original Prusa XL Mono Cabezal (Ensamblada) 29