Fronius RC Panel Basic Manual De Instrucciones página 30

General
Safety
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Danger due to welding processes starting unintentionally.
This can result in serious personal injury and damage to property.
▶
Device concept The remote control can be used with the following system components:
RC Panel Basic with SpeedNet connection socket
-
RC Panel Basic /BT
-
-
-
RC Panel Basic TIG/TMC with TMC connection socket
-
-
When using the remote control, the parameters are set and functions selected
depending on the welding process and power source.
NOTE!
As a result of firmware updates, you may find that your device has certain func-
tions that are not described in these Operating Instructions, or vice versa.
Certain illustrations may also differ slightly from the actual controls on your de-
vice, but these controls function in exactly the same way.
30
WARNING!
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this device
and all system components.
WARNING!
Once the remote control has been connected, the welding process can be
started using the welding torch or the remote control. Make sure that the
welding process is not initiated unexpectedly at any point.
System components from the TPS/i series
System components from the TPS/i series
System components from the TT/MW series (with Bluetooth function)
Only in certified countries
System components from the TT/MW series (with TMC connection socket)
System components from the TP series (with TMC connection socket)