Fronius MTB 180i CMT Braze+ Manual De Instrucciones página 17

WARNING!
Danger due to hot system components and/or equipment.
This can result in serious burns or scalding.
▶
Before starting work, allow all hot system components and/or equipment to
cool to +25°C/+77°F (e.g., coolant, water-cooled system components, wire-
feeder drive motor, etc.).
▶
Wear suitable protective equipment (e.g., heat-resistant gloves, safety gog-
gles, etc.) if cooling down is not possible.
WARNING!
Danger from electric current due to defective system components and incor-
rect operation.
This can result in serious personal injury and damage to property.
▶
All cables, leads, and hosepacks must always be securely connected, unda-
maged, and correctly insulated.
▶
Only use adequately dimensioned cables, leads, and hosepacks.
NOTE!
Never use water-cooled welding torches without coolant.
The manufacturer is not responsible for any damage resulting from improper use.
All warranty claims are considered void in such cases.
NOTE!
When disconnecting a welding torch from the cooling unit or wirefeeder, always
seal the coolant hoses using the plastic seal attached to the torch.
17