Fronius MTB 180i CMT Braze+ Manual De Instrucciones página 22

Troubleshooting
Troubleshooting
no shielding gas
all other functions present
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Wirefeed issues
For applications with long hosepacks
Cause:
Remedy:
Welding torch gets very hot
Cause:
Remedy:
Cause:
Remedy:
22
Gas cylinder empty
Change gas cylinder
Gas pressure regulator faulty
Replace gas pressure reducer
Gas hose not attached, or damaged
Attach or replace gas hose
Welding torch faulty
Change welding torch
Gas solenoid valve faulty
Inform the service team
Improper laying of the hosepack
Lay hosepack as straight as possible while avoiding tight bending radii
Welding torch is inadequately sized
Observe duty cycle and load limits
For water-cooled systems only: Coolant flow too low
Check coolant level, coolant flow rate, coolant contamination, etc.
For more detailed information, refer to the Operating Instructions for
the cooling unit