Sinbo SHC 4358 Manual De Instrucciones página 6

ENGLISH
SINBO SHC-4358 HAIR CLIPPER
INSTRUCTION MANUAL
Thank you for choosing SINBO®. Our products are designed to meet the highest standard of quality,
functionality and design. We hope you enjoy using your new SINBO® appliance. Please read the
instructions for use carefully and keep in a safe place for future reference.
CAUTION
Use this appliance only for its intended use as described in this manual. Do not use attachments not
recommended by SINBO®.
Do not use this product if it is not working correctly, if it has been dropped or damaged, or dropped into
water.
PARTS DESCRIPTION
2
1. On/Off switch
3
2. Blade set
3. Taper lever
4
1
4. 4 attachment guide combs
HOW TO USE
Before starting the cut
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
To attached a comb
Hold the comb with its teeth upward.
Slide it onto and along the clipper blade until the front of the comb firmly sits against the clipper blade.
To remover the comb
Holding the clipper with the blades facing away from you, firmly push the comb upward and away from
the blades.
Comb Attachments hair lengths
Each comb attachment is marked accordingly on its outside middle surface(3mm, 6mm, 9mm, 12mm)
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair. Do not force
it through quickly. If you are cutting for the first time, start with the maximum comb attachment.
STEP 1- Nape of the neck-DIAGRAM 1
Use 3mm or 6 mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the center of the head at the
base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time.
- 5 -