Working Modes; Config Mode - JabloCom EYE-02 Instrucciones De Uso

WATCH
SLEEP

3.3 Working Modes

The EYE-02 camera has three main working modes: SLEEP, WATCH and CONFIG.
Mode
SLEEP mode is the camera's stand-by mode. The camera doesn't detect
any movement in the targeted area and the major detectors are disabled.
The only active detectors are those that protect the camera itself against an
SLEEP
unwanted manipulation by an intruder.
In WATCH mode, the camera guards fully the targeted area and all detectors
WATCH
are active.
CONFIG mode allows the user to change the camera settings and switch the
camera to other special modes (ENROLL, TEST, USB).
CONFIG
The chosen camera mode is terminated by switching to a different camera mode. Camera signalizes its current mode
to the user by LED lights and acoustic signals.
Camera Mode
WATCH
SLEEP
EN
CONFIG
ES
ENROLL
DE
ERROR
FR
Incorrect operation
with remote control
Camera is starting
NO
up or shutting down
or USB mode is in
progress
1
FI

3.4 Config Mode

CONFIG mode allows the user to change the camera's settings.
To enter CONFIG mode using the remote control, press the
LED lights on the front panel will start to blink slowly together.
From CONFIG mode is possible to switch to other special modes (ENROLL, TEST, REPORT, USB).
1 The Red light goes out when the fault has been resolved or the user has switched mode.
EYE-02.ENG.MAN.User_Manual.23.C
Remote control navigation
Description
LED lights signaling
Lights are off.
Green light is permanently on.
Red and Green lights blink slowly
together.
Red and Green lights slowly blink
alternately.
Red light is permanently on
Green light flashes rapidly
CONFIG
.
1
and buttons simultaneously – the red and green
- 6 -
ENROLL
TEST
REPORT
Button on
the Remote Control
and
together
Acoustic signal
One long beep
Two long beeps
Three long beeps
One short beep
Four short beeps