Profiles - JabloCom EYE-02 Instrucciones De Uso

MODE
In ENROLL mode, the camera allows new external wireless devices to be
enrolled, such as remote controls, detectors, sirens, etc. A new contact phone
ENROLL number can also be enrolled in this mode, by simply calling the camera.
ENROLL mode is terminated automatically after one new item has been
enrolled.
TEST mode is a special mode for testing the functionality of all detectors
TEST without causing a number of unwanted alarm reports. The camera beeps and
blinks after any of the sensors is activated.
In REPORT mode, the camera sends a special report to all contacts (call,
MMS etc.) according to the camera settings.
REPORT
Example of an SMS from the camera: Camera EYE-02 reports: User origina-
ted camera test External wireless device RC-80(1), Time:13/11/2008 11:33:49.
In this special mode, the camera acts as a standard USB flash disk. It allows
USB access to files on the SD memory card without a special camera driver being
installed on the PC.
To protect the camera, special modes will be closed automatically after a 5-minute time-out and the
camera will return to CONFIG mode.

3.5 Profiles

The EYE-02 camera offers a fast and simple way of setting all necessary detector parameters by selecting one
of pre-defined profiles. These profiles are suitable for most camera applications. If necessary, the profile may be
further adjusted by the user in JabloTool software or via JabloTool web portal available on www.jablotool.com.
• HOME
The HOME profile has been designed for camera installation inside
a building (house, flat, office). During WATCH mode, there are no move-
ments of people, gusts of wind, significant temperature changes or loud
noises expected.
• OUTDOOR
The OUTDOOR is suitable for installation of the camera outside your
home. The camera significantly reduces the sensitivity of the detectors
in OUTDOOR mode because there are many sources which could po-
tentially cause a false triggering of the alarm - sunshine, animals, street
noise, wind, etc.
For outdoor installation see chapter 5.5.
• GARAGE
This profile is suitable for installation inside your garage. It is similar to the
HOME profile. Additionally, the GARAGE profile provides a 30-second
entrance delay. It allows you to open the garage or home entrance door first
and switch the camera to the SLEEP mode during this delay.
• CARE
The CARE profile has been designed specifically for monitoring small chil-
dren and elderly or disabled people.
Using the camera with the CARE profile allows
the user to leave the home, stay a short distance away
from home and watch their sleeping baby or unwell
relative at the same time. The camera is activated by any
movement or by a PANIC alarm (triggered by a personal
wrist button)
The internal acoustic camera signals are disabled in the CARE profile. The CARE profile is the only
profile where the TILT detector is blocked to allow camera manipulation.
EYE-02.ENG.MAN.User_Manual.23.C
DESCRIPTION
- 7 -
COMMAND
press the and but-
tons simultaneously for about
4 seconds
Press the power button
CONFIG mode for 3 seconds
(until camera emits 4 beeps)
in
EN
ES
DE
FR
NO
FI