Publicidad
Idiomas disponibles
Idiomas disponibles
Remote Control Button Definitions:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
button: Turns the fan off.
button: Controls fan direction.
Your DC brushless motor is equipped with an
automatically learned type remote control. There are
no frequency switches on the receiver; the receiver
unit will automatically scan the frequency from the
remote control if any changes are made. The
frequency settings on the transmitter should be
changed ONLY in case of interference or if a
second or more ceiling fans with the same type of
control system are installed in the same structure.
Setting the Remote Control
Follow the below steps to set the remote control:
The auto learning function will only mandate within
60 seconds when turning the fan's AC power ON.
a) Select desired frequency from the transmitter.
The dip switches can be set to 16 different
combinations. (Fig. 20)
11. Operating Your Transmitter
b) From the back of the transmitter, with the
fan's power off, restore power to the fan. Press
and hold "SET" button for about 5 seconds and
release. If optional light kit is installed, the
light kit will flash twice and the signal light on
the hand held transmitter will come on when the
button is pressed. The fan has completed the
pairing process with the remote control and is
ready for use. (Fig. 20)
NOTE: If the self calibration test failed, turn the AC
power off; restore power and process the self
calibration test again.
NOTE: During self calibration test, the remote is
non-fuctional.
NOTE: The learning frequency function and self
calibration test will continue to retain the last set
frequency and calibration set even when the AC
power is shut off. If the frequency is changed the self
calibration test will occur again.
Figure 19
ON ECE
1 2 3 4
ON ECE
1 2 3 4
Figure 20
Publicidad
