Progress Lighting 17169-G Manual De Instalación página 8

WARNING
FAILURE TO PROPERLY INSTALL
CLEVIS PIN AS NOTED IN STEP 5
COULD RESULT IN FAN LOOSENING
AND POSSIBLY FALLING.
NOTE: If a longer downrod is needed, take out
the screw located in the hanger ball, lower the
hanger ball and remove the pin, remove all 3
pieces from the downrod and assemble them onto
the new longer downrod before proceeding step 3.
(The longer downrod is available at any Progress
Lighting retailer)
Option 2:
Close-to-Ceiling Mounting
Remove the canopy ring from the canopy.
1.
(Figure 5)
2. Remove the mounting bracket from the canopy
by loosening the four screws on the top of the
canopy. Remove the two non-slotted screws
and loosen the slotted screws. (Figure 6)
3. Remove the decorative canopy bottom cover
from the canopy by turning the canopy bottom
cover counterclockwise. (Figure 8)
5.
Canopy
Bottom
Cover
4.
Remove three of the six screws and lock
washers (every other one) from the collar of
top motor. (Figure 9)
5. Route the wires exiting the top of the fan motor
through the canopy ring (make sure the slot
openings are on top). then proceed to place the
ceiling canopy over the collar at the top of the
motor. (Figure 10)
6. Align the mounting holes with the holes in the
motor and fasten using the screws and lock
washers removed in step 4. (Fig. 10)
7. Tighten the mounting screws security.
WARNING
FAILURE TO COMPLETELY TIGHTEN
THE THREE SCREWS IN STEP 7 COULD
RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Motor
Collar
Remove
Figure 8
Collar
Ceiling
Canopy
Screw and Lock Washer
(3 of 6 Places)
Figure 9
Screw and
Lock Washer
(3 Places)
Canopy Ring
Figure 10