Publicidad
Idiomas disponibles
Idiomas disponibles
TO DESCALE
1. Empty the drip tray and re-insert into
position on the machine.
2. Fill the water tank to the DESCALE line
indicated and add the descaling agent
to the water.
1000
DESCALE
3. Place a 2L / 68 fl.oz container under the
portafilter and steam wand.
4. Turn the machine off by simultaneously
pressing the 1 CUP and STEAM buttons,
1000
and allow it to completely cool before
DESCALE
descaling.
1000
DESCALE
5. With the machine off, press the 1 CUP
1000
DESCALE
and STEAM buttons simultaneously for 5
seconds to enter descale mode.
OR
6. The 1 CUP and STEAM buttons will
illuminate, indicating that the machine
MAX
OR
is ready to start descaling.
OR
MAX
7. Press the 1 CUP or STEAM button to
begin the descale cycle. These buttons will
alternately flash throughout the cycle.
18
2
L
68oz
+
2
L
68oz
+
2
L
5s
68oz
OR
+
5s
2
L
68oz
&
+
0.5s
5s
&
0.5s
&
&
8. Once the descale solution has been used up,
the descale mode will pause. Refill the water
tank to the MAX line and empty the waste
water container, then replace both parts on
to the machine.
9. The 1 CUP and STEAM buttons will
illuminate when the machine is ready.
Press the 1 CUP or STEAM button to
resume descaling.
10. When descaling is complete, the 1 CUP and
STEAM button will alternately flash. The
machine will then go into standby mode.
5s
11. Remove and empty the waste water
container. Rinse the drip tray and water
tank and dry thoroughly before replacing
MAX
them back onto the machine.
0.5s
STEAM WAND BLOCKED
During milk texturing, if the machine detects that
the steam wand is blocked, it will immediately
stop operating and the STEAM button light
will be off. Both the milk temperature and milk
foam lights will fully illuminate and flash. These
lights will flash until a manual steam purge has
been completed.
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand
0.5s
with a damp cloth.
• If any of the holes in the tip of the steam
wand become blocked, it may reduce frothing
performance. Manually purge the steam
wand to try and clear the holes.
• If the steam wand remains blocked, unscrew
the steam wand tip using the steam tip
cleaning tool, then use the tool to unblock the
holes; cleaning tool is located in the back of
the machine, under the water tank.
+
OR
CLEANING THE STEAM WAND
5s
0.5s
&
Publicidad
