Lavor GV 3.0 VAC Instrucciones Para El Uso página 20

EN
Zmax = 0,11 Ohm (EN 61000-3-11:2000)
5. USAGE
5.1. STARTING UP
When preparing the appliance for use, switch
it off and unplug it!
- Fill the tank (J) with water (fig. 4)
Do not put any kind of detergent or chemical
substance in the water tank!
- Fill the tank (J1) with detergent (fig. 5)
This appliance is designed for use with the
detergent supplied or recommended by the
manufacturer. The use of other detergents or
chemicals may put the appliance's safety at
risk!
- Fit the plug (H1) of the flexible hose (L) in the
vacuum connection (H) (fig. 9, 10, 11).
Never use the appliance without a filter!
5.2. VACUUMING DUST
• Fit the most suitable accessory in the handle of
the flexible hose (L).
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch (B).
• Vacuum by pressing button (L1)
5.3. STEAM CLEANING
• Fit the most suitable accessory in the handle of
the flexible hose (L).
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch (B).
• Press lever (L3) for steam outflow.
• Turn on the steam system using switch (E) and
wait until "steam ready" light (D) lights up.
• For the outflow of the steam, press the lever
(L3). The first amount of steam will come out
with water condensation; direct the jet to one
side or onto a cloth.
• Pre-select the amount of steam using the knob
(F) located on the appliance. The gauge (R)
indicates the pressure inside the boiler.
• To steam and vacuum simultaneously: it
is possible to use the above-mentioned
steamcleaning functions together.
• Vacuum by pressing button (L1)
20
• When work is finished, release the steam lever
(L3) a few moments prior to switching off the
suction motor (L1). This will allow the suction
ducts to recover the humidity.
5.4. STEAM CLEANING + INJECTION HOT
WATER OR DETERGENT
• Fit the most suitable accessory in the handle of
the flexible hose (L).
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch (B).
• Turn on the steam system using switch (E) and
wait until "steam ready" light (D) lights up.
• Start injection pump by selection switch (P) :
H2O II hot water or
I detergent.
• To help the primer of the injection pump, turn
the steam tap (F) off .
• Press the lever (L3)
• Pre-select the amount of steam using the knob
(F) located on the appliance. The gauge (R)
indicates the pressure inside the boiler.
• To steam and vacuum simultaneously: it
is possible to use the above-mentioned
steamcleaning functions together.
• Vacuum by pressing button (L1)
• When work is finished, release the steam lever
(L3) a few moments prior to switching off the
suction motor (L1). This will allow the suction
ducts to recover the humidity.
5.5. TOPPING UP THE BOILER WATER TANK
WITH WATER
• The boiler water tank (L) supplies the boiler
through an electronic level control; since this is
an external tank, it can be topped up any time.
• When water runs out in the boiler water
tank:
1. the appliance beeps intermittently
2. the no-water level pilot light (C) flashes
3. the steam stops coming out
To top up, proceed as follows:
• Switch off the boiler switch (E)
• Turn off the main switch (B)
• Remove the cable from the socket
• Fill the boiler water tank (J)