Publicidad
3.
Spread a thin layer of glue in the two dowel holes at the top and in the enlongated hole of the
Right Front Leg (C). Making sure the pocket drilled holes face down, insert a Stretcher (F) into the
enlongated hole. Gently tap into place with a rubber mallet. Making sure the pocket drilled holes face
down, insert the Axle (G) into the large hole at the bottom. Spread a thin layer of glue in the enlongated
hole in the Right Back Leg assembly (B). Position the Right Front Leg (C) assembly over the dowels on
the Top Assembly and fit the Stretcher and Axle into the corresponding holes on the Right Back Leg
assembly (B). Gently tap into place and quickly wipe away any excess glue. Using the predrilled holes
as guides and the provided hex wrench (T or ZH), affix with two 6x40mm Hex Screws (P). See Figure 3.
Fig. 4
4.
Spread a thin layer of glue in the dowel holes at the top and the enlongated hole in the Left
Front Leg (E). Making sure the pocket drilled holes face down, insert a Stretcher (F) into the
enlongated hole. Insert the Towel Bar (H) into the middle hole. Genly tap in place with a
rubber mallet. Spread a thin layer of glue in the enlongated and dowel holes in the Left Back Leg (D).
Position the Left Front Leg assembly over the two dowels and insert the Stretcher (F) and Towel
Bar (H) into the corresponding holes in the Left Back Leg assembly. Gently tap with a rubber
mallet and quickly wipe away any excess glue. Using the provided hex wrench of your choice
(T or ZH), affix with two 6x40mm Hex Screws (P). See Figure 4.
4303KFBA_Page 4_12/09
B
F
Fig. 3
D
G
F
H
P
C
P
P
E
P
x 2
x 2
Publicidad
