Publicidad
Q
NOTE: Dowels are visible on one side of each wheel. Be sure to turn those faces to the inside.
7.
Place one 28mm Flat Washer (U) and one Wheel (K) over the axle. Thread one 6x60mm Hex
Screw (Q) through one 8mm Flat Washer (R), the wheel/washer and into the axle. Tighten using
the provided hex wrench (T or ZH) of your choice. Repeat for the second wheel. See Figure 7.
Fig. 8a
R
P
J
8.
Position the cross bar of the Drop Leaf Support (J) against the stops of the Drop Leaf (S). See
Figure 8. Thread one 6x40mm Hex Bolt through the Drop Leaf Support and place one 8mm Flat
Washer (R) over the bolt. Using the provided hex wrench (T or ZH) of your choice, attach to the
cart. Repeat for the opposite side. See Figure 8a.
4303KFBA_Page 6_12/09
R
U
K
J
Stops of Drop Leaf
Q
R
U
K
Fig. 7
Fig. 8
S
Q
x 2
x 2
R
x 2
U
P
x 2
x 2
R
Publicidad
