Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
6
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
7
TROUBLESHOOTING
Problem
The motor shuts
down whilst
working.
The machine
smokes during
operation.
The motor is on,
blades do not
move.
NOTE
NOTE
Possible cause
Solution
Make sure that
The battery pack
you tighlty instal-
is not installed
led the battery
tightly.
pack in the ma-
chine.
The battery pack
Charge the bat-
is out of power.
tery pack.
The machine
Do not use the
has damage.
machine and
speak to service
center.
1. Immediately
stop the ma-
chine.
The machine
2. Remove the
has damage.
battery.
3. Speak to
service cen-
ter.
Do not use the
The machine
machine and
has damage.
speak to service
center.
Remove battery
The blades are
then clear block-
blocked.
age from the
blades.
English
Problem
Too much noise
and/or vibration
is experienced
while working.
8
TECHNICAL DATA
Voltage
No load speed
Blade speed
Blade length
Cutting capacity
Weight (without
battery pack)
Measuered sound
pressure level
Guaranteed sound
power level
Vibration
Uncertainty
Battery model
Charger model
9
WARRANTY
(The full warranty terms and conditions can be found on
®
greenworks
webpage)
®
The greenworks
and 2 years on batteries (consumer/private usage)
from the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described
in the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
6
Possible cause
Solution
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loosen.
damage.
4. Check and
tighten loose
parts.
Do not use the
The parts have
machine and
damage.
speak to service
center.
60V
-1
3200 (±10%) min
-1
3200 (±10%) min
510 mm
30 mm
4.2 kg
80 dB(A), K
=3 dB(A)
PA
94 dB(A)
2
≤2.5 m/s
2
1.5 m/s
G60B2, G60B3, G60B4, G60B6
and other BAC series
G60C, G60UC, G60UC4,
CAC814 and other CAC series
warranty is 3 years on the product,
Publicidad
