Publicidad
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended
oil and fuel.
If you have any problems
with the assembly
of
your pressure
washer,
please call the pressure
washer helpline
at 1-800-222-3136.
IMPORTANT:
Any attempt to run the engine before it
has been serviced with the recommended
oil will result
in an engine failure.
REMOVE PRESSURE WASHER FROM
CARTON
•
Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
•
Remove hose reel box, fillers, and parts box
shipped with your pressure washer.
•
Roll the pressure washer out the open end of the
carton.
•
Raise guide handle, secure in place.
Lift the handle to
upright position and
slide the locking caps
into place
•
Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
•
The main unit
•
Hose reel components
•
Parts box (which includes items listed below)
High pressure hose
Spray gun
Nozzle extension with Hi/Lo adjustable nozzle
Engine oil
Operators manual
Nozzle cleaning kit
O-Ring kit
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 7. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING
YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
•
Attach hose reel.
•
Add oil to engine crankcase.
•
Add fuel to fuel tank.
•
Connect high pressure hose to the spray gun and
the pump.
•
Connect water supply to the pump.
Assembling
Hose Reel
IMPORTANT: You must take the hose off the reel
when operating your high pressure washer. The reel is
for storage purposes only.
•
Attach the handle to the reel with Iocknuts,
flatwashers, and bolts as shown.
•
Secure the hose reel to the left side upright, (from
behind the unit), with Iocknuts, flatwashers, and
bolts. See page 7 for location.
M6 Bolts
M6 Flatwashers
J
/
/
/
M6 L!ckwasher
M8 Bolts
M8 Locknuts J
M8 Flatwashers
Publicidad
