Uline H-4441 Manual Del Usuario página 6

TWO-PIECE BACK PANEL
IMPORTANT! When two-piece backs are used,
center rail is installed on upper back.
(See Figure 10)
1. After center rails are in place, install lower back
panel. Install splicer rail over lower back panel,
then install upper back panel. (See Figure 10)
NOTE: If ceiling height is not adequate to drop
panels from top, insert one side edge and flex
panel until other edge fits in place.
(See Figure 10)
Figure 10
Center Rail
2. Install base end trims, upright end trims and top rails.
(See Figure 11)
NOTE: To install upright end trim, hook top of
upright end trim over top of upright, then press
down toward floor.
Figure 11
PAGE 6 OF 23
ASSEMBLY CONTINUED
Splicer Rail
INSTALLING BASE BRACKET END TRIM
1.
2. Place rear flange of base bracket end trim against
NOTE: To remove top rail, pull toward upright
and lift up. Insert flathead screwdriver through
top rail slot, press its blade against one top rail
tab and twist top rail to disconnect tab. Repeat
for other tab. (See Figure 12)
Figure 12
Insert front flange into front of base bracket
adjacent to closed base front. (See Figure 13)
base bracket hook and slide down. (See Figure 14)
IMPORTANT! Base bracket end trim must slide
behind front and rear flanges on base bracket
to be properly seated.
IMPORTANT! Base bracket end trim must be
installed before base decks.
Figure 13 Figure 14
0224 IH-4441