Piusi SQUALO35 Instalación Uso Y Mantenimiento página 32

Installation, use and maintenance
12 CONNECTIONS
12.1 ELECTRICAL CONNECTIONS
ATTENTION
WARNING
SINGLE
PHASE
WIRING
SINGLE
PHASE
WIRING
DIAGRAM
ATTENTION
ATTENTION
32 /112
IT IS THE INSTALLER'S RESPONSIBILITY TO CARRY OUT THE ELEC-
TRICAL CONNECTIONS IN COMPLIANCE WITH THE RELEVANT STAN-
DARDS.
Comply with the following (not exhaustive) instructions to ensure a proper
electrical connection:
- During installation and maintenance make sure that power supply to the
electric lines has been turned off.
- Use cables with minimum sections, rated voltages and installation type
that are suitable for the characteristics indicated in paragraph "TECHNICAL
DATA" and the installation environment.
Connect the cable of the single phase pump to the electric panel, ensuring
that the following parts correspond:
GREEN/YELLOW CABLE
BROWN CABLE
BLUE CABLE
The pump should be installed with an electric panel guaranteeing the follow-
ing functions: overload protection, short circuit protection, dry run protection.
DO NOT MODIFY AND / OR MAINTAIN THE CONFIGURATION OF THE
ELECTRICAL PARTS.
TAMPERING OF THE ELECTRICAL PARTS CAN CAUSE
UNEXPECTED ALTERATIONS IN ELECTROMAGNETIC EMISSIONS.
The pump must be installed with an electrical panel that guarantees the fol-
lowing functions:
- overload protection;
- short-circuit protection;
- dry running protection.
During installation and periodically, provide for verification of the ground-
ing circuit in compliance with current regulations.
LINE
NEUTRAL
M0467