Publicidad
Idiomas disponibles
Idiomas disponibles
SNAPPER
To
TROUBLESHOOTING
Problem
Pump
has following
problems:
failure
to produce
pressure,
erratic
pressure,
chattering,
loss of
pressure,
low water
volume.
Detergent
fails to mix with spray.
Engine runs good at no=load
but
"bogs"
when load is added.
Pressure
washer
stops during
operation.
Cause
1.
Nozzle
in low
pressure
mode.
2.
Water
inlet is blocked.
3.
Inadequate water supply.
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
6.
Water supply is over I00°E
7.
High pressure hose is blocked or
leaks.
8.
Gun leaks.
9.
Orifice
is obstructed.
10. Pump is faulty.
I.
2.
3.
4.
Detergent
siphoning tube is not
submerged.
Chemical filter is clogged or
cracked.
Dirty in-line filter.
Nozzle is in high pressure mode.
Engine speed is too slow.
Out of gasoline.
Correction
I.
Pull nozzle backward for high
pressure mode.
2.
Clear inlet.
3.
Provide adequate
water flow.
4.
Straighten
inlet hose, patch
leak.
5.
Check and clean inlet hose
strainer.
6.
Provide cooler
water
supply.
7.
Clear blocks in outlet
hose.
8.
Replace gun.
9.
Clean orifice.
IO. Contact
Briggs and Stratton
Power
Products
service facility.
I.
Insert detergent
siphoning
tube
into detergent.
2.
Clean or replace
filter/detergent
siphoning
tube.
3.
See "Check
In-Line Filter".
4.
Push nozzle forward
for low
pressure
mode.
Move throttle
control
to FAST
position.
If engine still "bogs down",
contact
Briggs and Stratton
service
facility.
Fill fuel tank.
Publicidad
