Publicidad
Idiomas disponibles
Idiomas disponibles
Add
Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
* Refer to engine manual for oil and fuel fill information.
* Damage to equipment
resulting from failure to follow this
instruction
will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations
and instructions.
NOTE:
Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
Connect
Hose and Water
Supply to
Pump
IHPORTANT:
To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
I.
Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 4).Tighten
by hand.
__
Connect high
pressure hose here
2.
Attach other end of high pressure hose to high
pressure outlet on pump (Figure 5).Tighten
by hand.
.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6). Clean screen if it contains
debris or replace if damaged. Refer to "O-Ring
Maintenance"
section on page 13 if inlet screen is
damaged. DO NOT run pressure washer if inlet screen
is damaged.
__
Inspect
inlet
screen. DO NOT
use if damaged;
clean if dirty.
4.
Run water through your garden hose for 30 seconds
to clean out any debris.
iMPORTANT:
DO NOT siphon standing water for the
water
supply. Use ONLY
cold water
(less than I O0°F).
5.
Connect
garden
hose (not to exceed
50 feet in length)
to water
inlet.Tighten
by hand (Figure 6).
CAUTION
Damage
to equipment
resulting
from failure to follow this
instruction
will void warranty.
6.
Turn ON water
and squeeze
trigger
on gun to purge
pump system
of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist
Before
Startin EgEn__gine
Review the unit's assembly to ensure you have performed
all of the following.
I.
Hake sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper fuel to fuel tank.
4.
Check for properly tightened hose connections.
5.
Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
6.
Provide a proper water supply at an adequate flow.
7.
Be sure to read "Safety Rules" and "HowTo
UseYour
Pressure Washer"
before using the pressure washer.
Publicidad
