Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
iMPORTANT:
Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove
Pressure Washer
From
Carton
1.
Remove parts bag packed with pressure washer.
2.
Slice two corners at end of carton from top to
bottom
so pane[ can be folded down flat, then remove
all packing material.
3.
Roll pressure washer out of carton.
Carton
Contents
Items
in the
carton
include:
• Main Unit
• Safety Goggles
• Handle
• High Pressure Hose
• Spray Gun
• Adjustable
Nozzle Extension
• Oil Bottle
• Parts Bag (which includes the following):
•
Owner's
Manual
•
Engine Manual
•
Owner's
Registration
Card
•
Handle
Fastening
Hardware
Kit (which includes):
•
Carriage Bolts (2)
•
Plastic Knobs (4)
•
"U' Hooks (2)
PREPARING
PRESSURE
WASHER
FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure
washer
helpline at [=800=3 17=7833.
To prepare your pressure washer for operation, you
will need to perform these tasks:
I.
Fill out and send in registration
card.
2.
Attach
handle to main unit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect
high pressure
hose to spray gun and pump.
6.
Connect
water
supply to pump.
7.
Attach
nozzle extension
to spray gun.
Attach Handle to Unit
I.
Place handle assembly
onto handle supports
connected
to main unit. Make sure holes in handle align with
holes on handle supports
(Figure
I).
Handle
Align
Handle
Supports
NOTE:
it may be necessary
to move the handle supports
from side to side in order
to align the handle
so it will slide
over the handle
supports.
2.
Insert carriage
bolts through
holes from outside
of the
unit and attach
a plastic [<nob from inside of unit
(Figure 2).Tighten
by hand.
%
3.
Insert one"U'
hook through
hole just above billboard
on [eft side of handle
(viewing from front of unit). Hold
hook in place and attach a plastic [<nob from inside of
unit (Figure 3).Tighten
by hand.
.
Spray Gun Hook
,,"
//
//
/
/
/'
ii
Hose Hook
Insert other
"U' hook through
hole just below
billboard
on right side of handle
(viewing from front of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten
by hand.
Publicidad
