Publicidad
Idiomas disponibles
Idiomas disponibles
.
Start
engine
according
to instructions
given in engine
owner's
manual.Also
see operating
instructions
tag
located
on the pressure
washer.
|WARNING
. When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
. If engine starts and fails to continue
to run or if increased
resistance is felt during starting pull attempts,
squeeze trigger
on spray gun.
NOTE:
Always
keep
the
throttle
lever
in the
"Fast"
_osition
when
operating
the
pressure
washer.
WARNING
. DO NOT touch
hot surfaces.
. Allow equipment
to cool before touching.
. The pressure
washer
must
be at least 5 feet from
structures
having combustible
walls and/or
other
combustible
materials.
. Keep at least 3 feet of clearance
on all sides of pressure
washer
for adequate
cooling, maintenance
and servicing.
. In the State of California
a spark attester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other
states
may have similar laws. Federal
laws apply on federal
lands. If you equip the
muffler with a spark attester,
it must be
maintained
in effective
working
order.
How
to StopYour
Pressure Washer
I.
Let engine
idle for two
minutes.
2.
Turn
engine
off according
to
instructions
given
in
engine
owner's
manual.
3.
Squeeze
trigger
on
spray
gun
to
relieve
trapped
pressure
in hose
to avoid
iniury.
NOTE:
A small
amount
of water
will squirt
out when
)ressure
is released.
WARNING
Keep high pressure
hose connected
to pump and spray gun
while
system
is pressurized.
Squeeze
trigger
on spray gun to relieve trapped
pressure,
every time you stop engine.
Engage trigger
loci< on spray gun.
4.
Engage trigger
loci< on spray gun when not in use.
Publicidad
