JBM 53934 Manual De Instrucciones página 9

REF. 53934
Step 2 (Shown as following diagram)
Pass hexagonal bolt M8X50 (43) of semicircular head
through the corresponding hole, flat gaskets(45) and
the anti-loosening nut M8(44). Pass half-round head
hexagonal M8X20(42) bolt through flat gasket (45), and
insert to corresponding hole, don't lock too tight.
Step 3 (Shown as following diagram)
Pass the hexagonal M8X50 screw (43) through the co-
rresponding hole, flat gaskets (45) and M8 anti-loose-
ning nuts (44). Screw the hexagonal M8X20 full-tooth
screw (42) and eight large flat gaskets (45) into the co-
rresponding hole with the hexagonal M8X20 full-tooth
screw (42) of the semi-circular head. Do not screw too
tight.
Step 4 (Shown as following diagram)
Turn on the power supply, put the safety lock on the
corresponding position, the treadmill enters standby
state, press the start key on the treadmill, the treadmill
get motive.
(Attention: The clamp on the safety lock must be clam-
ped on the suit during running).
Emergency Stop Function: After the safety lock is
pulled off, the power supply is disconnected, and
the weak part of the power supply is maintained.
For your safety, when exercising, be sure to use
safety locks!
PRODUCT USE
1. When you plug in the power and turn on the switch
(the switch is red), you will hear a "drop" and then
the screen will light up. The screen system needs
to wait patiently for a while before it enters the start
interface.
2. Place the safety lock on the yellow area, press the
start button to start the treadmill, and clamp the
safety lock clip on it. In case of accident, pull off
the safety lock immediately and stop running im-
mediately.
3. Unfolding Instruction: The treadmill fold to save
space, turn off the power supply and unplug the
power plug before folding. Raise the running deck
by hand till it is stuck (a "click" sound will be emitted
when lifted to the stuck position.)
4. When you want to put down the running deck, hol-
ding the running deck by hand, kick the buckle of
the air spring with your foot, and then release your
hands till you hear a "click" sound, the treadmill will
automatically slow down to (Shown as diagram
below).
PANEL OPERATION INSTRUCTIONS
Find red safety
1. Panel diagram as right.
lock in tool pack,
put the magnetic
2. Press Start key to start the treadmill after put on
end on the yellow
safety lock.
mark positional,
3. The treadmill begins to work counting down 3 se-
press start key
conds after press Start key.
to start.
4. Saftey lock functioN: Put off safety lock, the ma-
chine will stop to motive quickly, E7 show on the
screen, tripping sound from the treadmill to remind
it will stop. Put the safety key on panel position, all
screen data will return to original after 2 seconds.
5. Press buttons:
START KEY:
When the treadmill stops, press the start button and the
speed shows "1.0" to run. The treadmill stops running
automatically after 99 minutes.
· 9 ·
Kick hear
to put
down
running
deck