Publicidad
Idiomas disponibles
Idiomas disponibles
3
Installation
.
3.1 Installation Site Requirements
Note: The ground should be able to bear the weight of the pool.
Note: There should be a water draining system around
Note: In order to prevent the danger of electric shock, please do not use the
adaptor to connect the pump.
Important Tips
The ground shall be smooth and flat, and there shall be no sharp objects. The
user should also consider the total weight of the user, SPA and water, and
ensure that the ground in the use area has Sufficient strength to support the
tub. There is a good drainage system beside the installation area. If the SPA
is installed in a place that does not meet the safety requirements, the
consumer is responsible for the loss caused by improper use.
1) Indoor installation:
Some special requirements for indoor installation that need to be paid
attention to:
◎ During the installation of the SPA, during the filling and draining water,
water may spill on the ground, so a floor drain and moisture-proof device
must be installed there.
◎ When SPA is used, it will bring a large amount of water vapor, and there
should be no articles and appliances that are easy to be affected with damp
in the use area.In order to ensure air quality and user comfort, it must be
installed in a good ventilated environment.
Note: Do not install SPA on carpets or other items that are easy damaged by
water.
2) Outdoor installation:
◎ The ground where spa pool is on must be flat and there are no sharp
objects such as branches and stones nearby.
◎ Do not use in an environment with the temperature below 10℃. It will
affect the heating effect of SPA.
◎ Also do not expose SPA to the sun for a long time, which will shorten the
service life of SPA.
◎ There should be a good drainage system near SPA pool,as SPA needs to
drain.
08
3.2 SPA pool assembly
Warning: Please use SPA's matching pump to inflate the pool, and do not
over inflate it. Please do not use other high-pressure air pumps for inflation.
The normal working pressure of the pool is 5.0KPa/0.725psi. Excessive
pressure will cause to burst or damage the joins of the pool.
a) Take the pool on the ground,connect the threaded end of the inflatable
tube to the inlet with bubble mark on the pump(see figure 1&2) and inflate
the SPA pool with another end of the inflatable tube.(see figure 3)
1
3
b) Connect the power plug of the SPA pump into the adapted power socket,
press the bubble jet button to start inflating the SPA pool (see figure 4
above)
Please fill the air chamber on the side wall of the SPA pool first. If the
inflatable top cover is provided, fill the top cover as well.
2
4
09
Publicidad
