Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Before using pool chemicals, please consult qualified technician for
more maintenance information. Pay close attention to the chemical
manufacturer's instructions. Abuse of SPA or improper use of chemicals,
resulting in SPA damage and life injury, consumers shall be responsible for
the improper use.
After each use of the SPA pool, we recommend that
you use bromine reagents and the chemical floaters
to disinfect the water in the pool. First open the cap
of chemical floaters, then add some bromine
reagents, and cover the cap. Put the floaters into
the SPA pool. We recommend that you activate the
bubble function while the water in the pool is being
disinfected,so that the circulation of water and
disinfection can be more sufficient. Please look at
the following illustration:
Warning: SPA cannot be used while it is being sterilized. The maximum
amount of chemicals should not exceed 20 tablets, otherwise the chemicals
will destroy SPA, and chlorine-containing chemicals should not be used.
5.3 Clean SPA
Dirt on the body, swimsuit and scale in water are easy to adhere to SPA pool
and pump body after heating, so it is necessary to wipe the surface of SPA
pool with soft cloth and neutral detergent frequently, and use a fine brush to
wipe the scale attached to the water inlet and outlet to prevent scale from
blocking the water inlet and outlet, thus affecting the normal use of SPA
pump.
Note: Do not use hard brushes to clean the surface of the pool.
5.4 Repair SPA
If the SPA punctures and leaks air, the repair patch in the attached repair kit
can be used for repair. Before repair, the SPA should be drained and deflated,
and the damaged part should be wiped clean. Cut the repair patch into a
shape of appropriate size, coat it with matching glue, and paste it onto the
damaged part. Do not use the newly repaired SPA within 12 hours.
5.5 SPA storage
According to the above-mentioned SPA drainage steps, ensure that the water
in the SPA pool and the control box has been drained, take out the filter
cartridge, and wipe the SPA pool and SPA pump clean with cotton cloth,
which can prolong the service life of the SPA. It is recommended that you
store the SPA in the original package and put it in a warm and dry place.
16
Note:
It is strictly prohibited to store the SPA pool in an environment below 0℃.
Plastics tend to become brittle under low temperature environments or
exposed to sunlight for a long time, which can shorten service life.
Consumers are responsible for damage caused by improper storage in winter.
If SPA is not used for a long time, the residual water in SPA pool and SPA
pump must be dried, otherwise peculiar smell will be caused by deterioration
of water quality.
6. Simple troubleshooting
Failure
Possible phenomena
SPA Cannot run
Not powered on
RCD Trip
Residual current device
damage
SPA No heating
Temperature set too low
Filter cartridge too dirty
The water level is too low
Electric heating does not
work
The bubble
When the pump
function does
temperature is too high
not work
The 30 minutes
temperature protection
are automatically turned off
SPA automatic pump
Water filtration
Filter cartridge dirty
does not work
The inlet and outlet pipes
are blocked
Control box error
Solution
Check power supply
Reset RCD Or the power
cord load is not up to
2000W Or 10A
If it cannot be started,
please contact after-sales
service
Set a higher temperature
Cleaning/replacing filter
cartridge
Continue to fill the water
and raise the water level
Call for help
Disconnect the plug and
wait for the pump to cool
before starting
Restart Bubble button.
If it cannot be
started,please contact
after-sales service
Cleaning/Replacing filter
cartridge
Check if the water inlet and
outlet are blocked by foreign
bodies such as scale
If it cannot be started,
please contact after-sales
service
17
Publicidad
